What Car Amplifier Do I Need for My Alpine Type-R Subwoofer?
Here at Sonic Electronix we give our customer the option and opportunity to ask us questions regarding car audio. One of the most common questions that we receive is What Amplifier Do I Need? For the next couple of weeks we will be looking into some of our top rated woofers and we will be pairing them with the perfect amplifier to make your car audio system run efficiently and smoothly. This week we will be taking a look at Alpine Type-R Series Subwoofers.
Kicker’s ZX500.1 monoblock amplifier is the perfect choice when looking to amplify a single SWR-1043D or a single SWR-1243D Alpine subwoofer. The ZX500.1 has a power rating of 500W RMS at 2 ohms which is enough power to properly run any of those two subwoofers when wired in parallel to a final impedance of 2 ohms. The Kicker amp will actually exceed the rated power meaning you get more bang for your buck. The ZX500.1 features a tuned bass EQ, variable low-pass filter, and a subsonic filter for complete control of the sound reproduction. The amplifier is CEA-2006 compliant meaning you get the power you paid for and also features a high-density convection heat sink for extreme heat dissipation, allowing you to run the Type-R for long periods of time without losing efficiency.
Massive D 1200
Massive Audio’s D 1200 monoblock amplifier is the amplifier to go with when wanting to amplifier a single SWR-1023D or a single SWR-1223D Alpine subwoofer. These subwoofers can be wired individually to either a final impedance of 1 ohm when wired in parallel or 4 ohms when wired in series. The D 1200 will require you wire which ever subwoofer you go with to a final impedance of 1 ohm. The amplifier offers a small chassis for convenient installation and a 6-way protection circuitry for complete protection of the car audio system. It also features an N-channel circuitry for high-efficiency eliminating clipping and cutting that usually occurs on less efficient amplifiers.
Polk Audio PA D1000.1
The Polk Audio PA D1000.1 will allow you to run the SWR-1023D or the SWR1223D to a final impedance of 4 ohms. This is the best way to go, the amplifier will run at the up most efficiency and so will the woofers. The PA D1000.1 can also be used if wanting to amplify two of these subs instead of just one; this will have to be done to a final impedance of 1 ohm on the amplifier. The amplifier features a variable bass boost, low-pass filter and subsonic filter for a custom sound reproduction. While the included wired remote bass level control adds convenience.